How to Attach a Locking Cup Holder Anywhere: Mini Disc Guide

Installation Guide: Mini Disc Locking Base

How to install the Mini Disc Locking Base using the included industrial strength double-sided adhesive or self-tapping screws.

What is included to attach the Mini Disc Locking Cup Holder: Three double-sided adhesive squares and three self-tapping screws.

What's Included?

(x1) Mini Disc Locking Base
(x3) Double-sided adhesive squares
(x3) Self-tapping screws

View the Mini Disc Product Page

Reference Images

See Images Below for Dimensions.

Option 1: Install Using Screws

Tools Needed: Phillips Screwdriver

Before You Start

Want the strongest setup? Go for the screws! Pick your spot, and double-check that it’s safe to drill into first.

Step 1

Pick a flat surface, align your Mini Disc, and mark those screw holes.

Step 2

Phillips screwdriver in hand? Perfect. Start those screws, but only halfway—we’re leaving room for adjustments here! We’ll tighten ‘em up in a sec.

Step 3

Once all screws are started, tighten them up going diagonally, back and forth, for that even grip.

*Pro tip: Don’t overdo it. Once it’s nice and snug, stop tightening.

Finished!

Give it a wiggle! If it feels solid, you’re all set.

Now, the grand finale: grab your TwistLock drinkware, twist it in, and enjoy your new spill-free life. Cheers to that!

Option 2: Install Using Adhesive

Tools Needed: Clean Rag or Towel

Before You Start

If you are attaching the Mini Disc with the included double-sided adhesive, use ALL of the adhesive squares for maximum strength.

STEP 1

Alright, time to clean! Give the back of the Mini Disc and your chosen spot a good wipe-down. Water or isopropyl is perfect—get it so clean you could eat off it.

*Most important: Let it dry completely. The cleaner and drier, the better the stick.

Step 2

Now for the sticky part! Fit all 3 adhesive squares to the back of the Mini Disc and press the adhesive down. Red side to the mount works best!

*If the red backing’s being stubborn, grab a knife and coax it off (carefully!).

Step 3

Peel off the other side of the adhesive—it’s go-time! This is the side that’s about to meet its new best friend.

Step 4

Press that Mini Disc firmly onto your spot of choice.

*72-hour patience break: Let it set for 72 hours, and dream of all the spills you’re not gonna deal with.

Step 5

After 72 hours, you’re all set! Twist in your TwistLock drinkware, lock it down, and voilà! You’re now a member of the No-Spill Squad. Welcome aboard!